STAINLESS STEEL LINEAR FLOOR SHOWER DRAIN WET ROOM BATHROOM CHANNEL GULLY TRAP
STAINLESS STEEL LINEAR FLOOR SHOWER DRAIN WET ROOM BATHROOM CHANNEL GULLY TRAP
STAINLESS STEEL LINEAR FLOOR SHOWER DRAIN WET ROOM BATHROOM CHANNEL GULLY TRAP
Stainless Steel LINEAR FLOOR SHOWER DRAIN
Length range:
30cm, 40cm, 50cm, 55cm, 60cm, 65cm, 70cm, 75cm 80cm, 85cm, 90cm, 95cm, 100cm, 110cm, 120cm
Measurements:
Channel width measured outside: 70mm
Width of the tile tray measured inside: 50mm
Please note: there is additional 20mm each side for the peripheral edges all around the drain, which go underneath the floor during the mounting.
Height of the tile edge inside the tray: 12mm - applies to the tile-able model ONLY
Height of the installation ONLY 52mm = ULTRAFLAT
Does not require a deep cut to install - low installation height - works well even if the slab isn't very thick
For more detailed measurements - see the drawing in the photo gallery.
Materials and main features
The drain is made of stainless steel AISI 304 1.2mm thick with nickel content at least 8%. Fine, clean weld seams - fully welded - not spot welded.
Siphon made of stainless steel with removable debris collector/fluff filter allowing easy cleaning with access from the top. It also blocks bad odours/smells from the drains and acts as a shield against loosing small jewellery like rings, earrings etc. = the trap is included
Use the grey plastic connector to connect this drain to the 50mm pipe (connector is included in the set).
It needs to be pushed onto the steel end of the drain and the other end pushed into the 50mm pipe (push fit)
If your pipes are 40mm diameter, there is no need to use the plastic connector as the steel outlet of the drain is 40mm diameter.
All our drains come with 10 years guarantee
***
The package includes:
1 x stainless steel drain channel
1 x removable debris collector
1 x removable protecting sieve
2 x adjustable and removable feet
1 x sealing waterproof cloth
1 x plastic connector/adaptor for 50mm pipe
1 x metal hook for lifting the tile tray
1 x installation instruction
1 x stainless steel patterned cover - only with drains with patterned grate
1 x stainless steel tile tray - only with tile-able drains
PRACTICAL TIPS
Before you buy a drain take a measurement of the space you've got in your shower room. Make sure to leave 10cm on each side for a comfortable installation (unless you work with a very skilled installer/tiler - than it can be 5cm on each side). For a less visible effect - so the linear drain 'melts onto' the floor - choose the tile-able model.
If you want the installation done quicker and easier and you like one of our stainless steel cover designs, then go with the covered drain and avoid having to cut the tiles.
For installation of our product, for the best results, use a polymer glue for joining the grey plastic connector with a pipe (if you need to use it at all) and then seal it with a cement solvent (polymer glue, like: Flex, High Tack, FixALL, etc.)